In addition to the correct use of wire saw, the regular maintenance and maintenance, if improve the wire saw cutting efficiency and extend the service life of the important guarantee. There are common problems and fixes in using wire saw:
1. If the joint and adjacent beads wear excessively, it must be cut off and replaced in time, which can avoid accidents caused by sudden breaking of wire saw and reduce downtime.
2. When the beads of injection molding or rubber sealing wire saw appear loose relative to the wire saw, if the number of loose beads is not much, and not far apart from each other, in the case of effective use of wire saw, it is best to cut off the loose part, and then connect with the good one. If loose beads are scattered on the whole string of beads, can break loose beads, and then use waterproof tape to wrap the exposed steel wire; Or cut off the bead rope from the part where the bead appears loose, remove the loose bead, and connect the bead rope with the joint to continue to use.
3. If the bead becomes conical, usually because the bead string speed is too low, can increase its linear speed to improve.
